Gerber GS750 User Manual download pdf (Page 17)

Installation 9

5. Insert a screw, with a washer, into each of the holes at each

side of the plotter stand base.

6. Verify that the alignment between the plotter stand base and

the stand assembly is correct, then tighten the screws.

7. Push a tube cap in each open end of the plotter stand base.

8. Install the feet in the bottom of the stand base. If installing the

Caster Option, refer to the instructions packed with the

casters.

9. Return the plotter stand to its upright position.

Install Plotter on Stand

Lift the plotter onto the stand assembly. Be sure the two metal

tabs which project from the top of each leg assembly are inside

the end plates of the plotter. Install a Phillips screw through each

tab into the plotter assembly.

Mount Tool Rack

Mount the tool rack on the back of the GS750

plus

above the power

panel by installing the screws through the holes in the tool rack

and plotter.

Mount Roll Support Bars

1. To install the roll support bars behind the vanity panel, align

the ends of the bottom roll support bar with the lowest position

in the hole on each leg assembly.

2. Insert the ends of the bar into the top

of the holes and slide

the ends firmly down to the bottom

of the holes. Repeat this

procedure with the other two roll support bars.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 82 83

No comments

Gerber GS750 User Manual Page 17