Gerber GS750 User Manual download pdf (Page 18)

10 GS750

plus

Mount the Material

1. First insert the material core end plugs (hubs) into the material

rolls. To mount a roll of material on a roll support bar, lift the

bar to the top of the hole and slide it toward one leg assembly

to free the opposite end.

2. After mounting the material on the bar, return the free end to

its hole and slide it firmly down into the locked position.

Plotter Work Area

1. Place the GS750

plus

near the GRAPHIX ADVANTAGE system

so that the material feeds toward you. Leave about four feet

of space both in front of and behind the plotter to allow the

material to move freely. The cable is 10 feet long, so the

plotter need not be located immediately beside the console;

however, it should be close enough so there will be no strain

on the cable after installation.

2. Make sure the plotter is level. If it stands on an uneven

surface, use an adjustable wrench to adjust the feet on the

bottom of the leg assemblies.

Connect to the Plotter

CAUTION: Be sure power is turned off and the power cord is

unplugged at both the GRAPHIX ADVANTAGE and the plotter.

1. Insert the 9-pin connector at the end of the RS-232 cable into

the 9-pin RS-232 connector on the back of the GRAPHIX

ADVANTAGE. This connector is normally labeled Plotter or

COM Port 2.

2. Carefully align all pins. Use the connector thumb screws to

secure the cable to the system.

3. Insert the 25-pin connector at the end of the RS-232 cable into

the 25-pin RS-232 connector on the back of the plotter.

4. Carefully align all pins. Secure the cable to the plotter with the

connector thumb screws.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 82 83

No comments

Gerber GS750 User Manual Page 18