Gerber GS750 User Manual download pdf (Page 62)

54 GS750

plus

Fuse Replacement

Two spare fuses are included with the GS750

plus

Plotter. The

fuse holder is located between the on/off switch and the power

cord connector on the rear panel of the plotter.

To replace the fuse

WARNING: Turn off power at the plotter and the system and

disconnect from the power supply.

1. Unscrew and remove the RS-232 cable from the rear panel of

the GS750

plus

2. Remove the plotter power cord from the socket.

3. Insert a flat-tip screwdriver into the round, notched cover.

Remove the fuse carrier and fuse.

4. Examine the fuse and remove it if it is blown. Install a new

fuse of the same type and rating in the same place. If the

fuse blows again, contact the Gerber Field Service

Department.

5. Reinsert the carrier, making sure the carrier is inserted all the

way. Tighten the screw.

6. Reinstall the power cord and the cable connector. Turn the

power on at the system and at the plotter.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 82 83

No comments

Gerber GS750 User Manual Page 62