Gerber GS750 User Manual download pdf (Page 63)

PLOTTER ADJUSTMENTS

The section contains a troubleshooting guide to help identify

possible error conditions according to the symptoms displayed

and the recommended adjustment procedures.

It also contains a brief description of plotter adjustment problems

that should be handled by contacting Gerber Field Service

Department at 800-828-5406.

Note: Gerber warranties do not cover unauthorized repair. Some

service procedures require delicate adjustment of plotter parts. If

damage to your GS750

plus

plotter results from improper

unauthorized service, repair will NOT be covered by any Gerber

warranty.

Cover Removal

When making certain adjustments to the GS-750, you may find it

necessary to remove the covers from the sides of the plotter.

Instructions for removal are as follows:

RIGHT COVER

1. Remove the plotter cover (with the front panel keys) by

removing the Phillips head screws which hold the cover in

place (see steps 2 and 3).

2. Remove the screw located in the center of the top edge of the

plotter right end plate.

3. Remove the screw from the center of the bottom edge of the

plotter end plate (located between the screws for the plotter

stand assembly). Reach up from inside the plotter stand to

remove this screw.

4. Pull the cover toward you.

Be careful not to lift it so high that

the cable disconnects.

Pivot the cover to the front of the

plotter.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 82 83

No comments

Gerber GS750 User Manual Page 63