Gerber GS750 User Manual download pdf (Page 57)

ERROR CONDITIONS

The GS750

plus

is programmed to detect several

mechanical/electrical error conditions at power-up or during

operation. When an error condition occurs, the plotter will turn off

power to the stepper motors, flash the RUN lights, and sound a

steady tone.

To determine the error condition that stopped plotter operation,

follow these steps.

1. Press the RESET key to clear the error signal (flashing lights

and steady tone).

2. Press the RUN SINGLE key to display the error code number.

The RUN lights flash the same number of times as the error

number (once for Error 1, twice for Error 2, etc.). A short beep

indicates the end of the error message. Press the RUN

SINGLE key again to repeat the message, if desired.

3. Press the RESET key to clear the error display mode and

return to the initial off-line status.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 82 83

No comments

Gerber GS750 User Manual Page 57