Gerber GS750 User Manual download pdf (Page 25)

MATERIALS AND TOOLS

Materials

The GS750

plus

uses the same plotting materials as all Gerber

plotters. Gerber vinyl products in high performance or

intermediate grades are available in translucent, reflective, or

metallic finishes and come in a wide range of colors. Also

available are direct-cut screenprint stencil, ruby photo film, paint

masking material, rubber sandblast stencil material and heat

transfer materials. Consult your Gerber distributor for further

information about available materials, colors and prices. Always

insist on Gerber authorized materials for highest quality results.

To load material

CAUTION: It is recommended that you load material

without a tool in the carriage to prevent damaging the

knife blade.

1. Slide the roll of material to be used onto the material support

bar. Pull the end of the material away from and over the top

of the roll holder toward the plotter and feed directly onto the

rubber drum.

CAUTION: When power is on, the carriage spindle must

be moved only by using the slew keys. Attempts to

manually move the plotter drum, rotate or force the tool

up or down will damage the plotter.

CAUTION: While power is off, center the carriage by

gently pushing toward the center of its travel. Take care

to move the carriage slowly and firmly by gripping the

right end of the carriage housing, not by gripping the

carriage spindle.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 82 83

No comments

Gerber GS750 User Manual Page 25