Gerber GS750 User Manual download pdf (Page 53)

SPECIAL DIAGNOSTICS

In addition to the self-check tests that are part of the power-up

sequence, the GS750

plus

plotter can perform other special

diagnostics. The steps to access these diagnostics and their

functions are outlined below.

To access special diagnostics

1. Hold down the RESET key during power-up.

2. When a steady tone sounds, release the RESET key. There

will be two beeps followed by three beeps as the self-check

tests are completed. Then the lights above the RUN CONT

and RUN SINGLE keys will alternate. These alternating lights

mean that RESET was held at power-up and that a special

diagnostic can now be performed.

3. Access one of the special diagnostics described next by

pressing the slew key noted in the description.

Note: Only one special diagnostic can be accessed at each

power-up sequence. To access another diagnostic, turn the

plotter power off and then on again (as described above).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 82 83

No comments

Gerber GS750 User Manual Page 53