Gerber GS750 User Manual download pdf (Page 28)

20 GS750

plus

HELPFUL HINTS

! When you change materials, open the bail arms and roll the

material back onto the roll. Tape the ends securely to prevent

the roll from unraveling.

! Before unrolling vinyl for a job, determine how much material

you need. Check the length of the longest line in the job, or

the width of an automatically laid out sign or digitized design.

Remember that if you are plotting in the Axis Swap mode, you

need to consider the height of the job rather than its width.

! The most practical way to unroll material for a job is to use the

slew keys on the plotter. It is best to unroll more than enough

material, rather than "just enough," in case your estimate is

not accurate. You may also pull material from the roll by

hand. This may be the simplest method if you are plotting

relatively small jobs.

! When you have advanced enough material for the job, feed it

back through the plotter, or otherwise position it appropriately

according to the tool start position selected from GRAPHIX

ADVANTAGE. If you have a large quantity of material piling

up on the table, be sure to arrange the material in loose

accordion folds so it can feed easily. Make sure the material

is positioned to feed straight into the plotter rather than at an

angle.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 82 83

No comments

Gerber GS750 User Manual Page 28