Gerber GS750 User Manual download pdf (Page 50)

42 GS750

plus

Single Plot Exercise

1. Turn on the GS750

plus

. Load plotting paper, test the pen

manually, install the pen holder, and set the tool force to .5.

2. Using the slew keys, position the carriage spindle

approximately 1" from the front edge of the plotting paper.

Also, be sure that there are several inches of paper extending

past the carriage spindle and to the left of the plotter.

3. Send a plot file to the GS750

plus

plotter.

4. Press the RUN SINGLE key to plot the test exercise.

RUN CONTINUOUS KEY

Use RUN CONT to access the continuous plotting mode and

maximize the plotter's productivity.

To plot in continuous mode

1. Select either swivel or tangential knife mode by pressing the

SWIVEL KNIFE key. When swivel knife mode is selected, the

light above the SWIVEL KNIFE key is on.

2. Press RUN CONT. The light above the RUN CONT key

comes on and the GS750

plus

plots one job after the other

without waiting for user prompting between the jobs.

The GS750

plus

creates a waiting list, or queue, of jobs to be

plotted. When one job finishes plotting, the next job waiting in the

queue begins immediately.

When all jobs in the queue are plotted, the GS750

plus

remains on-

line until the operator presses either RUN key or the RESET key

to return to off-line status.

RUN

CONT

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 82 83

No comments

Gerber GS750 User Manual Page 50